Product selection context
Start with the mechanism.
Unionwell product reference for Micro Switch Engineering applications. Confirm the exact G5L configuration, electrical load, actuator, terminals, operating conditions, and current drawing revision with engineering before design approval.
Use this page as an on-site starting point, not as a substitute for a controlled drawing or model-specific datasheet. Final selection depends on the actual switch position, movement, circuit, operating environment, and validation plan.
Typical operating points to review
Power-tool trigger and on/off control
Translate trigger movement into a repeatable control input, with electrical loading checked against the selected model.
Discuss this positionLawn mower and garden equipment
Support user-control or mechanism-position detection in equipment exposed to vibration and outdoor conditions.
Discuss this positionGuard, handle, or cover position
Detect a safety cover or movable handle reaching its operating position.
Discuss this positionDusty or damp equipment zones
Shortlist protected switch configurations when dust, water, or cleaning exposure is part of the use environment.
Discuss this positionThese are application examples for project discussion. Confirm the exact configuration, ratings, approvals, and system-level suitability with Unionwell engineering.
Four checks before you shortlist a switch
- Define the signal. Identify the position or event the mechanism must detect, including normal, released, and fault states.
- Map the movement. Share actuator type, available travel, operating force, mounting envelope, terminal direction, and tolerance stack.
- Specify the conditions. State voltage, current and load type, switching frequency, temperature, moisture, dust, vibration, and expected operating life.
- Plan validation and supply. Include required approvals, sample and test expectations, annual volume, project stage, target timing, and drawing revision.
Send a drawing, mechanism photo, or incumbent part number with your RFQ when available. The team can then check the mechanical interface and electrical requirements together.
