OEM / ODM MICRO SWITCH SOLUTIONS

Engineering article · EV Charging

Micro Switches For New Energy

Unionwell is now providing kinds of automotive micro switches that can be used on new energy vehicles like electric cars. Unionwell has high-performance micro switches for electric cars and also other related occasions. Contact Us Now!

UNIONWELLunionwell-microswitch.com
Request quote
Micro Switches For New Energy
ARTICLEEV Charging

Engineering context

Translate this reference into a real application.

Unionwell is now providing kinds of automotive micro switches that can be used on new energy vehicles like electric cars. Unionwell has high-performance micro switches for electric cars and also other related occasions. Contact Us Now!

Use this page as an on-site starting point, not as a substitute for a controlled drawing or model-specific datasheet. Final selection depends on the actual switch position, movement, circuit, operating environment, and validation plan.

Typical operating points to review

EV charging equipment

Charging-gun release and lock

Detect button or lock movement and provide a position input to the charging control sequence.

Discuss this position
EV charging equipment

Vehicle inlet locking pin

Confirm the position of a compact locking mechanism during connection and release.

Discuss this position
EV charging equipment

Port cover and access door

Report whether an access cover or service door has reached its intended position.

Discuss this position
EV charging equipment

Charging-pile cabinet access

Provide a door-state input for equipment access monitoring and control interlocks.

Discuss this position

These are application examples for project discussion. Confirm the exact configuration, ratings, approvals, and system-level suitability with Unionwell engineering.

Four checks before you shortlist a switch

  1. Define the signal. Identify the position or event the mechanism must detect, including normal, released, and fault states.
  2. Map the movement. Share actuator type, available travel, operating force, mounting envelope, terminal direction, and tolerance stack.
  3. Specify the conditions. State voltage, current and load type, switching frequency, temperature, moisture, dust, vibration, and expected operating life.
  4. Plan validation and supply. Include required approvals, sample and test expectations, annual volume, project stage, target timing, and drawing revision.

Send a drawing, mechanism photo, or incumbent part number with your RFQ when available. The team can then check the mechanical interface and electrical requirements together.

Need a current specification?

Send the reference.
We will verify the model.

Start an RFQ